Hello Guest it is May 06, 2025, 07:37:29 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: How mach close position control loop?  (Read 4137 times)

0 Members and 1 Guest are viewing this topic.

Offline vahid

*
  • 2 2
How mach close position control loop?
« on: January 16, 2008, 04:04:53 PM »
Hi all! Hope everyone is doing well.
I am a new user for mach 3. I don't know how mach 3 close position control loop?
How use mach encoder signales connected to it?
Did mach use encoder signales for position control loo? or it use for monitoring propose only?
Thanks in advance for any help!!
 
 
 
Logged

Offline Chaoticone

*
  • *
  • 5,624 5,624
  • Precision Chaos
Re: How mach close position control loop?
« Reply #1 on: January 16, 2008, 04:32:29 PM »
I think most use the drive to monitor posotion and send a fault signal to Mach should it get out. Also, on your I/O card, can't see that unless it can communicate Via modbus.

Brett
Logged
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Pages: 1   Go Up
« previous next »