Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: vahid on January 16, 2008, 04:04:53 PM

Title: How mach close position control loop?
Post by: vahid on January 16, 2008, 04:04:53 PM

Hi all! Hope everyone is doing well.
I am a new user for mach 3. I don't know how mach 3 close position control loop?
How use mach encoder signales connected to it?
Did mach use encoder signales for position control loo? or it use for monitoring propose only?
Thanks in advance for any help!!
 
 
 

Title: Re: How mach close position control loop?
Post by: Chaoticone on January 16, 2008, 04:32:29 PM

I think most use the drive to monitor posotion and send a fault signal to Mach should it get out. Also, on your I/O card, can't see that unless it can communicate Via modbus.

Brett