Hello Guest it is October 31, 2024, 08:03:59 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Concept Validation: Dual Belt Spindle Setup  (Read 4723 times)

0 Members and 1 Guest are viewing this topic.

Offline tkalxx

*
  • 14 14
Re: Concept Validation: Dual Belt Spindle Setup
« Reply #10 on: February 17, 2021, 04:43:28 PM »
I'm confident I can get the auto shifter working in PMC based on RPM conditions. But tweaking the analog out signal for different belt ratios is way over my head haha!
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Concept Validation: Dual Belt Spindle Setup
« Reply #11 on: February 19, 2021, 11:43:50 AM »
You make it shift and I more than happy to help you with the analog side!
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline tkalxx

*
  • 14 14
Re: Concept Validation: Dual Belt Spindle Setup
« Reply #12 on: February 19, 2021, 12:14:37 PM »
Will do, thank you Brian.

I've started building some of the mechanical components. I will reach out to you on this thread once I reach the stage where analog modification is needed!
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Concept Validation: Dual Belt Spindle Setup
« Reply #13 on: February 19, 2021, 01:28:21 PM »
Nice! Looking forward to it.
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline tkalxx

*
  • 14 14
Re: Concept Validation: Dual Belt Spindle Setup
« Reply #14 on: April 12, 2021, 10:48:26 AM »
Quote from: Brian Barker on February 19, 2021, 01:28:21 PM
Nice! Looking forward to it.

Hi Brian, it's been a while, but I'm finally getting ready to start the programming side of things for my spindle.

Can you point me in the right direction on how to go about modifying the analog output calculation in Mach? I can't seem to find any code/scripts relating to analog output in my Mach4 directory.

-Adam.
Logged
Pages: « 1 2   Go Up
« previous next »