Hello Everyone,
I moved my computer and had to disconnect all the connections to my mach 3 lathe.
Now i have put it together again but I find that the spindle speed is not responding to the "s" word
I have put s500 in the general configuration startup string - but alas the spindle starts at maximum revs.
(In my case that is 1300) .
I have a vsd attached as well as a spindle speed monitor ( the little light that counts to speed of the spindle by counting a slot in a disc )
I need to get around to fixing this type of thing by myself without bothering you chaps all the time--
but where would be the logical point to start looking?
best regards
fred