Hello Guest it is May 25, 2025, 05:58:17 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Edge Cam & Mack 3  (Read 4484 times)

0 Members and 2 Guests are viewing this topic.

Offline Bob Hepple

*
  • 28 28
Edge Cam & Mack 3
« on: August 02, 2007, 02:40:02 PM »
 ???Can anyone help me I am looking for a post for edgecam that will mork with mach3. I was told Fanuc 6 or Fanuc 11 would work. does Anyone know where I can get these. Any help aprreciated.
Logged

Offline bondeoca

*
  • 20 20
Re: Edge Cam & Mack 3
« Reply #1 on: August 02, 2007, 09:02:51 PM »
Hello Bob
Try the edgecam users group on yahoo,they may have one in the files section.

Rick
Logged
Pages: 1   Go Up
« previous next »