Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Bob Hepple on August 02, 2007, 02:40:02 PM

Title: Edge Cam & Mack 3
Post by: Bob Hepple on August 02, 2007, 02:40:02 PM

 ???Can anyone help me I am looking for a post for edgecam that will mork with mach3. I was told Fanuc 6 or Fanuc 11 would work. does Anyone know where I can get these. Any help aprreciated.

Title: Re: Edge Cam & Mack 3
Post by: bondeoca on August 02, 2007, 09:02:51 PM

Hello Bob
Try the edgecam users group on yahoo,they may have one in the files section.

Rick