Hello Guest it is May 02, 2025, 09:32:00 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Noob question about Mach 3 Turn tool DRO #  (Read 3102 times)

0 Members and 1 Guest are viewing this topic.

Offline Inuk

*
  • 3 3
Noob question about Mach 3 Turn tool DRO #
« on: September 28, 2018, 05:53:44 PM »
Hi there,

Is there a way to automatically return the Tool DRO to the Master Tool after finishing a multi tool run.  Couple of times I neglected to reset the Tool DRO back to the master, for the next (repeat) job, which was interesting..... ::)
Phil
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: Noob question about Mach 3 Turn tool DRO #
« Reply #1 on: October 01, 2018, 06:15:02 AM »
Do you manually change tools? ie; quick change

RICH
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Noob question about Mach 3 Turn tool DRO #
« Reply #2 on: October 01, 2018, 07:31:49 AM »
Have it as the end of your code.
Logged

Offline Inuk

*
  • 3 3
Re: Noob question about Mach 3 Turn tool DRO #
« Reply #3 on: October 03, 2018, 11:12:41 AM »
That makes total sense. Thank you both.
Logged
Pages: 1   Go Up
« previous next »