Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Inuk on September 28, 2018, 05:53:44 PM

Title: Noob question about Mach 3 Turn tool DRO #
Post by: Inuk on September 28, 2018, 05:53:44 PM

Hi there,

Is there a way to automatically return the Tool DRO to the Master Tool after finishing a multi tool run.  Couple of times I neglected to reset the Tool DRO back to the master, for the next (repeat) job, which was interesting..... ::)
Phil

Title: Re: Noob question about Mach 3 Turn tool DRO #
Post by: RICH on October 01, 2018, 06:15:02 AM

Do you manually change tools? ie; quick change

RICH

Title: Re: Noob question about Mach 3 Turn tool DRO #
Post by: Hood on October 01, 2018, 07:31:49 AM

Have it as the end of your code.

Title: Re: Noob question about Mach 3 Turn tool DRO #
Post by: Inuk on October 03, 2018, 11:12:41 AM

That makes total sense. Thank you both.