Hello
Guest
it is
June 05, 2024, 02:57:51 AM
Guest
Login
Register
Menu
Home
Help
Search
Calendar
Members
Members
View the memberlist
Search For Members
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
Mach4 General Discussion
/
Spindle turn of mach
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Spindle turn of mach (Read 2760 times)
0 Members and 1 Guest are viewing this topic.
amnon
40
Spindle turn of mach
«
on:
July 04, 2015, 01:01:12 PM »
Hej,
Why is that, when program runs with M3(spindle on), after a few minutes Mach suddenly stop and Reset button is red. It doesn't happen when spindle is off. Is it cause by line interference?
Best Regards
Amnon
Logged
Steve Stallings
486
Re: Spindle turn of mach
«
Reply #1 on:
July 04, 2015, 01:12:59 PM »
If you have a VFD driven spindle or a spindle motor with brushes, the chances
are good that there is enough electrical interference to cause the problems
that you are seeing.
Logged
Steve Stallings
www.PMDX.com
amnon
40
Re: Spindle turn of mach
«
Reply #2 on:
July 20, 2015, 09:09:56 AM »
I've instaled interference eliminator, but still nothing. Kress stop all the time when start cutting. What can I do more?
May Relay have something to say, I mean if is not big enough?
Respect
Amnon
Logged
Steve Stallings
486
Re: Spindle turn of mach
«
Reply #3 on:
July 20, 2015, 10:44:34 PM »
Tell us more about your system, what version of Mach, what hardware interface?
Where did you install the filter?
What message is in the status line at the bottom of the screen when Mach stops?
Logged
Steve Stallings
www.PMDX.com
amnon
40
Re: Spindle turn of mach
«
Reply #4 on:
July 22, 2015, 10:03:58 AM »
Done - additional filter
Thank's
Logged
Print
Pages:
1
Go Up
« previous
next »