Hello Guest it is May 22, 2025, 02:20:31 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Toolpath Display Query  (Read 6731 times)

0 Members and 1 Guest are viewing this topic.

Offline 01sporty

*
  • 94 94
Toolpath Display Query
« on: February 11, 2007, 10:42:14 AM »
How difficult would it be to make the toolpath display in LC behave the same as the one in Mach? Personally, I would find it much easier to transition back and forth between the two if they worked in a more similar manner.
Regards,
Walt
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Toolpath Display Query
« Reply #1 on: February 12, 2007, 03:12:19 PM »
IT is not that simple but I can see why you would like to have that... I put it on the board
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Pages: 1   Go Up
« previous next »