Hello Guest it is February 22, 2026, 09:56:50 PM
Profile Guest
« previous next »
Pages: « 1 2 3 4   Go Down

Author Topic: Loosing steps when milling slowly  (Read 31682 times)

0 Members and 3 Guests are viewing this topic.

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Loosing steps when milling slowly
« Reply #30 on: March 13, 2011, 02:07:03 PM »
I only have experience of Gecko and Leadshine stepper drives and the motors run fine at any speed with them.
Hood
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: Loosing steps when milling slowly
« Reply #31 on: March 13, 2011, 07:31:19 PM »
I use Gecko drives and even the ones a friend made work at any speed and very well. Thus I can't speak for what you purchased, but, believe that's your problem.
RICH
Logged
Pages: « 1 2 3 4   Go Up
« previous next »