I forget to try, will ask. I hope, in HOLD position, pins state changed by modal codes don't reverse, isn't it? Not fatal, but better is to stay in place...

Sorry I dont what you are either saying or asking.

Hood

Mxx somewhere in the program changes output state of pin X from LOW to HIGH. I'm holding the Mach3 via LPT. What will happens with the pin X output level? Will go back to LOW or will stay HIGH as I ordered with Mxx?

Modal code for "coolant" for example, but this is just for example...

Hi Hood,

I checked... No surprise for you: of course NO acceleration and decelaration when opening the window.   

Frankly speaking: After Art said this, I didn't even believe that there woud be proper start or stop...


Konrad

Konrad, thanks for testing it out, would have been a handy thing if it did work.

Hood

Hi all!

Can you tell me about the resume of  last situation of g-code ,after user close the mach3 ?
By the way when we need to work off ,how can we  save the current gcode so user resume it(the next line of gcode) at last day!?

thanks.
mostafa