1
FAQs / Re: Mach 3 starts on computer but will not cycle start
« on: July 05, 2012, 05:10:16 AM »
Hi Alanchz,
Perhaps you should pay more attention to the settings in the ports & pins input and output settings menu. OK so its stopped flashing now and I can start the cycle. I have quit at this point to sort the wires out and avoid conflict with the scary moving table. Thanks for the help.
alanchz.
Perhaps you should pay more attention to the settings in the ports & pins input and output settings menu. OK so its stopped flashing now and I can start the cycle. I have quit at this point to sort the wires out and avoid conflict with the scary moving table. Thanks for the help.
alanchz.