Messages

1

FAQs / Re: Mach 3 starts on computer but will not cycle start

« on: July 05, 2012, 05:10:16 AM »

Hi Alanchz,

Perhaps you should pay more attention to the settings in the ports & pins input and output settings menu. OK so its stopped flashing now and I can start the cycle. I have quit at this point to sort the wires out and avoid conflict with the scary moving table. Thanks for the help.

alanchz.

2

FAQs / Re: Mach 3 starts on computer but will not cycle start

« on: July 04, 2012, 04:57:26 PM »

New installation, Reset flashing, selecting it has no effect, still wont cycle. Manual connections all ok but nothing through the software. Driver installed ok according to status bar. Any help appreciated.

Alanchz.