31
General Mach Discussion / Re: Mach3, Opt Laser 5W and Aspire
« on: February 24, 2021, 10:52:14 AM »
If I put a multimeter on the input 1 terminal 3 I can see 4.9v and if I run the gcode I can see it go on and off
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I have tried it and can see the laser light flashes slightly like it did when I tried the M3 S800 kind of like too lower laser power?
Allan
did you do the test with MDI?
Hi Allan,
This is really not going to work for you with two people making conflicting suggestions.
As I said earlier I leave it all to TPS.
Tweakie.