Hello Guest it is March 28, 2024, 05:45:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - A11an

Pages: 1
1
General Mach Discussion / Mach3, Opt Laser 5W and Aspire
« on: February 22, 2021, 05:36:23 AM »
Hi, I'm still learning but just to make it harder on myself I've installed an OPT Laser on my 3dtek Heavy Mill, I've managed to get it fitted and sort of working but struggling to get the laser to switch on and off, it does trigger on at the start and at the end but continuously on through the burning process. I've installed a post processor in aspire but to be honest I'm struggling to get my head around the whole laser thing. Do I need proper laser software or can I use aspire? I've probably missed a setting somewhere in Mach3, hope someone can help me out

thanks
Allan

Pages: 1