21
General Mach Discussion / Re: Six axis setup
« on: September 21, 2008, 09:49:53 AM »
Hi
Yes, I got that address and entered to Mach3. I also enable all axis, and changed some value( pls. see attached files). The second port have power, all two motor was bracked, but I can not move those axis( I named it by C and B axis), exept all original axis( witch connect to port 1) work well. Pls. guide me how to setting it up or what's I need to pay attention to.
Thanks
P/s: Sorry, I can not post files, pls. give me your E-mail address, or send me an E-mail at: namnp2007@gmail.com
Yes, I got that address and entered to Mach3. I also enable all axis, and changed some value( pls. see attached files). The second port have power, all two motor was bracked, but I can not move those axis( I named it by C and B axis), exept all original axis( witch connect to port 1) work well. Pls. guide me how to setting it up or what's I need to pay attention to.
Thanks
P/s: Sorry, I can not post files, pls. give me your E-mail address, or send me an E-mail at: namnp2007@gmail.com