Topics

1

General Mach Discussion / Need help: Homming and Jogging dir is in same side

« on: October 26, 2018, 03:12:10 AM »

Dear all
I have the problem for my Mach 3 CNC: If I change the dir of homming of any axis(i.e X axis), the direction of jogging of this axis is changed also. Please guide me to fix this problem. Thanks you so much.
Nam.

2

General Mach Discussion / Need drawing layout of interface board for AC servor motor

« on: December 14, 2008, 09:10:57 PM »

Hello all.
 I like to make my 3-axis CNC rought, using Mach3 software and 03 AC servo motor. Do some one can share me detailed drawing layout of interface board, so I can make it myself?
Thanks for your time.

3

General Mach Discussion / Six axis setup

« on: September 19, 2008, 11:45:26 PM »

Hi all
PLs. help me to setup my CNC machine, with six axis. I have two MaxNC controler, one PC with two LPT port, but can not setup the second port. Every help will be wellcome.
Thanks for your time