I need PHONE SUPPORT. I have a PAYPAL Account and understand the billing rate you charge.
MACH3 JOGING PROBLEM
Here is a problem that has me tearing out my hair.
Conditions:
1. All axis of mach3 work, x,y,z and will move with an MDI command.
2. All axis of mach3 work, x,y,z and will move when I REFERENCE ALL.
3. When I TAB over to the JOG Page pullout, none of the jog buttons will respond.
Problem is what can be wrong? The axis drives work, but, the machine will not JOG.
Since posting my problem on the yahoo and CNCZONE, I have:
1. disconnected the MPG from the computer, This allowed me to Get the Shuttle mode enabled (Flashing Yellow)
2. checked the the jog increment were set at 0.010
3. When I tried the JOG from SHUTTLE PULL OUT Jog Buttons - NO JOY.
System is MACH3 and the computer is a DELL running Windows7.
The system was working very well when I LAST USED it. That was in APRIL of thisyear, I live in arizona and the aveerage temperAture for the summer was over 105 degrees F.
My EMAIL address is M F G G U R U at COX.NET