1
G-Code, CAD, and CAM discussions / Re: ART CODE 9991
« on: April 23, 2012, 10:18:59 PM »
I think I found it.
The probe grid size was set to .25 inches in pcb-gcode but the actual grid in the g-code was .007 inches.
The 130,000 plus probing points just got it totally out of whack.
I changed the probe grid setting to 8 inches and now the grid size is .25 inches, and it doesn't crash
I may even try to etch a board tomorrow evening.
Thanks All
Jerry
The probe grid size was set to .25 inches in pcb-gcode but the actual grid in the g-code was .007 inches.
The 130,000 plus probing points just got it totally out of whack.
I changed the probe grid setting to 8 inches and now the grid size is .25 inches, and it doesn't crash
I may even try to etch a board tomorrow evening.
Thanks All
Jerry