1
General Mach Discussion / single axis plunge probe build
« on: October 27, 2015, 02:39:12 PM »
RE: single axis plunge probe build
I would like to build a probe that is spring loaded (1.25 travel). Mach3 or 4 would be controlling. I would use it in conjunction with the x axis on my machine. I would like to position/load the sensor and run the length of my work with the probe rising and following with the profile. Need a resulting 2d profile extrapolated(for profile regrind)from the x axis movement combined with data from the plunge probe.
Any ideas on how I should proceed? what components I will need to build this? Has anyone done a similar project?
Is there a reasonably priced product on the market that could work (hardware or software)?
I would appreciate any help/thoughts on with this.
Cheers,
Kyle
I would like to build a probe that is spring loaded (1.25 travel). Mach3 or 4 would be controlling. I would use it in conjunction with the x axis on my machine. I would like to position/load the sensor and run the length of my work with the probe rising and following with the profile. Need a resulting 2d profile extrapolated(for profile regrind)from the x axis movement combined with data from the plunge probe.
Any ideas on how I should proceed? what components I will need to build this? Has anyone done a similar project?
Is there a reasonably priced product on the market that could work (hardware or software)?
I would appreciate any help/thoughts on with this.
Cheers,
Kyle