2171
General Mach Discussion / Re: G4 Dwell time only reading whole numbers
« on: March 02, 2018, 02:06:18 AM »
After you have selected G04 Dwell in mS close Mach3 then restart.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I have been struggling with getting my Taig MicroProto mill running reliably. It seems that every time I go to use the mill, new problems arise. The first time that I was able to get the unit running, it worked great for about a day. The next time that I went to use the mill, I noticed that the inline fuse in the controll box failed each time I turned on the machine. I thought this might suggest a short somewhere in the circuit, but after having someone with an electrical background look at it, we couldnÂ’t see anything that was wrong. Does anyone know why this is happening every time I turn on the machine? Is this a voltage issue? I tried adjusting the potentiometer but nothing seems to make a difference. Could the motors be bad and causing a short?