1
General Mach Discussion / PowerMax30 THC - DIY with MACH3
« on: November 27, 2016, 04:54:13 PM »
Dear Friends
i bought second hand PowerMax30 of hyperterm
i built a cnc table with it but i want to attach THC.
i dont have the money to buy many THC controllers and i am looking for DIY electric board working additionally with MACH3 .
problems:
1. where i am finding DIY THC electric board?
2. to where should i connect it in the plasma? (attached electirc scheme of the plasma)
3. what should i do if i dont have feedback "arc ok(GOOD)" from the plasma? what i am using instead?
4. how should i connect all to MACH3?
thanks a lot to all
Best Regards
ASAF
i bought second hand PowerMax30 of hyperterm
i built a cnc table with it but i want to attach THC.
i dont have the money to buy many THC controllers and i am looking for DIY electric board working additionally with MACH3 .
problems:
1. where i am finding DIY THC electric board?
2. to where should i connect it in the plasma? (attached electirc scheme of the plasma)
3. what should i do if i dont have feedback "arc ok(GOOD)" from the plasma? what i am using instead?
4. how should i connect all to MACH3?
thanks a lot to all
Best Regards
ASAF