Hello Guest it is March 28, 2024, 04:19:34 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - asaf775

Pages: 1
1
General Mach Discussion / Re: PowerMax30 THC - DIY with MACH3
« on: November 28, 2016, 04:17:18 AM »
 :D :D :D :D :D :D

THANKS A LOT MIKE

2
General Mach Discussion / Re: PowerMax30 THC - DIY with MACH3
« on: November 28, 2016, 03:43:46 AM »
Dear Dave

Thanks a lot

i know about PROMA

but i thought maybe i can avoid from "Unnecessary financial expenses"

BEST REGARDS

3
General Mach Discussion / Re: PowerMax30 THC - DIY with MACH3
« on: November 28, 2016, 02:44:43 AM »
Dear DAVE

thanks

i thought doing what you are saying

but it will give me the voltage only, i dont know if there is a signal (wire)  for "arc ok" also, correct me if i am wrong please.

if you are using only the voltage as "arc ok" somehow, please explain.

second, i need to divide the voltage that supposed to fit to mach, do you know to what range of voltages? do you know electric diagram (attached example) fit to it?

thanks a lot

Best Regards and have a nice day

4
General Mach Discussion / PowerMax30 THC - DIY with MACH3
« on: November 27, 2016, 04:54:13 PM »
Dear Friends

i bought second hand PowerMax30 of hyperterm

i built a cnc table with it but i want to attach THC.

i dont have the money to buy many THC controllers and i am looking for DIY electric board working additionally with MACH3 .

problems:

1. where i am finding DIY THC electric board?
2. to where should i connect it in the plasma? (attached electirc scheme of the plasma)
3. what should i do if i dont have feedback "arc ok(GOOD)" from the plasma? what i am using instead?
4. how should i connect all to MACH3?

thanks a lot to all

Best Regards

ASAF

Pages: 1