I have pokeys57 device setup as an MPG. I can select which axis and which step size without issue. Using the pokeys software, i also verified that the encoder wheel works fine.
The issue is that in mach3 the MPG wheel does not move the axis. After a restart, i can select each axis and move them a very small amount, then no more. Sometimes, when i spam the "stop" button and turn the encoder wheel, the axis will also move.
The selected axis LED blinks fairly rapidly, and inconsistently, i.e. the pulses are not all the same duration, but they are always short.
Anyone have any ideas? Not that it should matter, but im not using external pullups, and the selected position shorts the pin to ground whereas the other positions are left floating.
attached are images of the configuration.
Anyone have any ideas on this strange issue? I'm sure its just a simple config issue that I don't know about, as I've never setup an MPG for Mach before.