I have a 750 saber with acramatic 850MC control that I am going to retro. Control will not run outside of manual mode? However my Fanuc servo and spindle drives and motors are working fine so I would like to keep them. I am planning on using the dspMC motion controller for servo motion, spindle, and I/O.
Question 1 to be on the safe side should I run two network cards, 1 dedicated to the motion controller and the other for file transfer within my shop network ?
Question 2 I am looking through my maintenance manual for my 12S Spindle (A06B-6059-H212) and I am trying to figure out the inputs and outputs to make it run. As near as I can tell it will communicate with the controller through CN1 and CN3 only. I have yet to find information on the CN3 connector and the 50 pin CN1 connector pin out in the book has tons of abbreviations I don't understand. I was wondering if anyone could help me decipher this.
Pin # Abbreviation
1 SAR1 6 OT 11 ALM1 16 SDT2 22 ORAR1 27 OVR1 45 SFR 50 SM1
2 SAR2 7 MRPDY1 12 ALM2 17 CTH 23 ORAR2 28 OVR2 46 SRV
3 SST1 8 MRPDY2 13 OR 18 OM 24 CTM 29 +15V 47 ESP1
4 SST2 9 TIM5 14 OS 19 ARST1 25 ORCM1 31 DA2 48 ESP2
5 TLML 10 TIM6 15 SDT1 20 ARST2 26 ORCM2 32 E 49 LM1
I need to know what they are, what voltage they are, which are inputs and which are outputs, are the all used, which are analog and which are digital?
Any Information on CN3? and What am I missing if you know of anything
FANUC Velocity control A06B-6050-H402 Connections to Control should be through CN6L, CN6M, and CN6N (K7) as well as CN1L, CN1M, and CN1N (K1)
K1 Pin abbreviation K7 (encoder?)
1 PRDY1 8 ALM1 14 PRDY 2 1 0V 14 PCZL 19 *PCBL
2 ENBL1 9 ALM2 15 ENBL 2 2 0V 15 *PCZL 20 SGL
3 OVL1 10 ALM4 16 OVL2 3 0V 16 PCAL
4 VRDY1 11 ALM8 17 VRDY2 8 OH1 17 *PCAL
7 VCMD 13 COML 20 ECL 9 OH2 18 PCBL
I need to know what they are, what voltage they are, which are inputs and which are outputs, are the all used, which are analog and which are digital?
What am I missing if you know of anything
Any help would be wonderful
Thanks