1
General Mach Discussion / Modbus input output support works with parallel port?
« on: October 05, 2017, 04:29:06 AM »
Dear experts,
i have question regrading parallel port. can any one tell me, when i activate "modbus input output support" in "configuration port and pin" my parallel port works properly.
means i want to give input signal to mach3 using "modbus input output support" and i want to give output to parallel port for controlling breakout board. both are working together without problem?Huh
i hope you can understand my question.
pls help me to figure out this problem.
thanks & regards
Parth Jetani
i have question regrading parallel port. can any one tell me, when i activate "modbus input output support" in "configuration port and pin" my parallel port works properly.
means i want to give input signal to mach3 using "modbus input output support" and i want to give output to parallel port for controlling breakout board. both are working together without problem?Huh
i hope you can understand my question.
pls help me to figure out this problem.
thanks & regards
Parth Jetani