Hello Guest it is March 28, 2024, 10:28:15 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - parth1799

Pages: 1
1
Dear experts,

i have question regrading parallel port. can any one tell me, when i activate "modbus input output support" in "configuration port and pin" my parallel port works properly.

means i want to give input signal to mach3 using "modbus input output support" and i want to give output to parallel port for controlling breakout board. both are working together without problem?Huh

i hope you can understand my question.

pls help me to figure out this problem.

thanks & regards
Parth Jetani

2
Dear experts,

i have question regrading parallel port. can any one tell me, when i activate "modbus input output support" in "configuration port and pin" my parallel port works properly.

means i want to give input signal to mach3 using "modbus input output support" and i want to give output to parallel port for controlling breakout board. both are working together without problem????

i hope you can understand my question.

pls help me to figure out this problem.

thanks & regards
Parth Jetani

Pages: 1