5831
General Mach Discussion / Re: quilting or embroidery machine
« on: August 22, 2012, 10:40:03 AM »
Hi John,
If connecting PC to machine via the Parallel Port there are only 5 available inputs per port so a second parallel card would be required or perhaps an external motion controller may be a better proposition.
Mach3 is intended to be fully customizable and I see no major problems with implementing most of the functions from buttons but I think you would also need a tracker ball (similar function to mouse) for some of the operations.
Ideally you would use a ‘touch screen’ display - creating positioning and labeling any new buttons as required using one of the various Screen Designer programs freely available. (Many of the button functions you mention are already on the screen, they would just need resizing with new captions etc.).
I am not certain about running the program backwards as I have never used the Reverse Run feature but it may be easier to scroll the program back then use Run From Here.
Tweakie.
If connecting PC to machine via the Parallel Port there are only 5 available inputs per port so a second parallel card would be required or perhaps an external motion controller may be a better proposition.
Mach3 is intended to be fully customizable and I see no major problems with implementing most of the functions from buttons but I think you would also need a tracker ball (similar function to mouse) for some of the operations.
Ideally you would use a ‘touch screen’ display - creating positioning and labeling any new buttons as required using one of the various Screen Designer programs freely available. (Many of the button functions you mention are already on the screen, they would just need resizing with new captions etc.).
I am not certain about running the program backwards as I have never used the Reverse Run feature but it may be easier to scroll the program back then use Run From Here.
Tweakie.