1
General Mach Discussion / Re: software settings dimensional vs radius movements
« on: March 22, 2021, 04:50:21 PM »
please look at the Quote that I posted above and it may describe my situation a little easier
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I am running a Mach 3 version R3.043.062.
Long story short, I'm trying to cut a diameter using the jog. My numbers on the MACH 3 DRO do not match the actual diameter of the part that I just turned. All settings are on Diameter mode. If I cut .02 of a .5 diameter the DRO shows me .480 while the part diameter measures .460. Is there any way to see the true number on the DRO. i.e. if I cut .02 radius the DRO shows a .04 Diameter change?
I figure this is a setting some place in the Mach3 program how do I change this?