Messages

11

General Mach Discussion / Re: MOTORS NOT TURNING !

« on: December 22, 2008, 07:48:16 PM »

Check field Axis Inhibits in tab Setting , if you see the LED is green, that mean this axis is inhibited, so it's can't be turn.

12

General Mach Discussion / Re: Need drawing layout of interface board for AC servor motor

« on: December 21, 2008, 08:40:46 PM »

Thanks Hillbilli.
For more information, pls. inform me that: If I watn to control 3( three) axis, do I need 3( three) board. And how to purchased it from you( I only can pay for you from my American friend, but could you shiped it to me, at Viet Nam)?
Thanks for your time.

13

General Mach Discussion / Re: Need drawing layout of interface board for AC servor motor

« on: December 21, 2008, 07:48:19 AM »

@derekpbcnc: But, could you give me the drawing, if you don't mind, any way?
Thanks for you time

14

General Mach Discussion / Re: Need drawing layout of interface board for AC servor motor

« on: December 21, 2008, 07:44:32 AM »

@derekbpcnc: Thanks.

15

General Mach Discussion / Re: Need drawing layout of interface board for AC servor motor

« on: December 21, 2008, 05:50:51 AM »

Dear scott
Thanks for your replay, but I mean that: Do I need some interface card, and could you show me the design of this card, so I can make it myself.
Thanks again
Sorry for my English

16

General Mach Discussion / Need drawing layout of interface board for AC servor motor

« on: December 14, 2008, 09:10:57 PM »

Hello all.
 I like to make my 3-axis CNC rought, using Mach3 software and 03 AC servo motor. Do some one can share me detailed drawing layout of interface board, so I can make it myself?
Thanks for your time.

17

General Mach Discussion / Re: Six axis setup

« on: September 25, 2008, 09:15:57 PM »

@osphoto:
I tryed as your post, but it's not work. But thanks, any way.
to all:
Pls. help me.

18

General Mach Discussion / Re: Six axis setup

« on: September 22, 2008, 11:26:39 PM »

@Hood:
Thanks for your time, I'll try late.
@osphotor:
Thanks. I will try it.
@all
Is someone hare have experience about it?

19

General Mach Discussion / Re: Six axis setup

« on: September 22, 2008, 09:58:10 AM »

Hi Hook
No , I tryed both enable or unenable this option, but when I enable this, the second port have power, all two motor was braked, but I can't move it , even at JOG mode( pls. note that on this mode, all original axises work fine.
Pls, guide me how to enable this port( step by step), for exemple: Firt: check enable second port,
Second: check.....
Third: .....
....
....
Thanks

20

General Mach Discussion / Re: Six axis setup

« on: September 21, 2008, 08:16:32 PM »

Dear Hood
I'm not sure about my port, do you have some truted name of port production?
Could you guide me to set it up, step by step, and every thing I need to change or check. I followed some e-mail like that, but it's only say about fourd axis.