Hi Steve
I'm not a Plasmaspider contributor so I can't down the file. But I did find the forum post that talks about how to get it going and there is some good clues in there.
https://www.plasmaspider.com/viewtopic.php?f=58&p=197265It is worth trying that post yourself - I could try and run the post but I can't test it on my machine as we have different torch height control systems. But lets put that off for a bit.
But before we worry about getting the post processor correct I need to step back to the start with this and confirm the following things are working:
Probing - In the MDI can you command a probe and dose it work? Yes or No?
Turning the torch off and on. in the MDI can you command the torch on and off? Yes or No?
ARC okay signal working. When the torch is firing do you get an Arc OK signal in Mach 4? Yes or No?
Can you start by confirming all these functions are working and the signals are being seen by Mach 4.
After that we need to the Torch Voltage is being read okay into the Price unit OK. - if that is good we need to get the Price control box set up correctly to suit different materials.
Can I ask what plasma source you are using? The manual for your plasma cutter will give you the required cutting voltages for each material. In the Price control box you set different cut voltages for each material.
Once the Price box is set for the correct voltage it will output up and down signals into Mach 4 to control the torch height. The Price box can simulate up and down moves to Mach 4. Can you do this simulation and is Mach 4 receiving these signals?
If you can confirm if all the above functions work OK then I can be sure if it is a problem with your machine or the post processor.
I'm sorry this is hard to do from a long way away and I just need to know what is happening. Don't worry we will get it going.
Steve