51
CVI MachStdMill (MSM) / Re: Touch off
« on: September 13, 2010, 07:00:25 AM »
Hi Dave
Yes I am the plonker was not doing it quite correctly , I was expecting the that after pressing the Set Z Zero arrow that the "Z" axis would move down to touch the touch plate , so to get this right I assume that I manually move the "Z" axis down to touch onto the touch plate and then click onto the Set Z Zero arrow ??
Thanks
Alan
Yes I am the plonker was not doing it quite correctly , I was expecting the that after pressing the Set Z Zero arrow that the "Z" axis would move down to touch the touch plate , so to get this right I assume that I manually move the "Z" axis down to touch onto the touch plate and then click onto the Set Z Zero arrow ??
Thanks
Alan