4
« Last post by grsfldflyer on May 17, 2024, 10:41:53 AM »
M62 requires a small move on the next like or motion won't start. I have had problems with motion not starting with M62 even with G0 or G1 move immediatly after. I'm still investigating the cause. M64 does not need a move.
M62: Synchronized Output On
Turns on an output synchronized with the start of the next motion command. If no motion is commanded, the output will not turn on. It is best to specify motion immediately following the M62 command.
Format: M62 P_
P specifies the output number to turn on. For example: Output0 = 0, Output3 = 3, Output10 = 10, etc.
M63: Synchronized Output Off
Turns off an output synchronized with the start of the next motion command. If no motion is commanded, the output will not turn off. It is best to specify motion immediately following the M63 command.
Format: M63 P_
P specifies the output number to turn off. For example: Output0 = 0, Output3 = 3, Output10 = 10, etc.
M64: Immediate Output On
The specified output is turned on immediately. Format: M64 P_
P specifies the output number to turn on. For example: Output0 = 0, Output3 = 3, Output10 = 10, etc.
M65: Immediate Output Off
The specified output is turned off immediately. Format: M65 P_