I get this error from Mach3 after setting up a Taig mill, Gecko G540 and Mach3. The parallel port is recognized, I went through setup, the green light on the Gecko comes on and the motors were slightly warm but never moved. The red Reset button in Mach3 is blinking and I cannot shut it off.
Anyone ever hear of this error? The only question I have is on the G540 instructions which say in Step 6 to jumper positions 10 and 12. I didn't do this as Step 7 says to hook the E-Stop switch to the same positions.
A motor wiring problem? Any ideas?