Thanks Terry,
this is a quite fresh install since I went through all my spare PCs. I just set them all at 35000 for kernel speed. No G04 after the M03 Terry, just move to cut height and commence XY moves.
I'm starting to remember some years ago I mentioned this problem on the Candcnc forum and after a bit of push push I got a reply of something along the lines of there's a fault in the plugin !!!!!!! I'll have to try and find that one.
This is the interesting thing. I increased the THC DELAY to 5 seconds and the Fault Delay in the cut profiles to 5 seconds also, and what happened
?? The pause in motion increased to 5 seconds also !!!!!! That says to me there's something in the Candcnc plugin causing this.
I've had enough of this old Candcnc system and I want nothing more to do with it. The PN200 I bought always had those rogue steps as did many others. I'm going to move to a basic system with breakout boards and an external THC. I don't want any more of this old plugin stuff and proprietary electronics. The new Candcnc stuff might be better but I never seem to have had a trouble free run with this old MP3000.
Keith.