1
CS-Lab / Re: CSMIO I/O both Sink and Source
« on: January 14, 2016, 12:25:06 AM »
Hi guys, I'm sorry to resurface this thread but I need help with confirming the same issue and this was brought up in the searches.
is it safe to use a different power supply for the inputs than the one being used for the CSMIO unit?
I have tested EStop by connecting it to pin 1 and pin 14 as follows:
+24V -> EStop switch -> pin 1
0V -> pin14
is that the same principle as what was discussed at top of the thread? thanks!
is it safe to use a different power supply for the inputs than the one being used for the CSMIO unit?
I have tested EStop by connecting it to pin 1 and pin 14 as follows:
+24V -> EStop switch -> pin 1
0V -> pin14
is that the same principle as what was discussed at top of the thread? thanks!