1
General Mach Discussion / Re: Loosing position during movement to part zero position after machining
« on: February 19, 2013, 08:57:47 AM »
Hood thanks I will try that - ( turning off the toolpath display on the diagnostic page)
on the other hand there is no issues with the axis or the drives, this is confirmed buy the fact that - immediately if we run a new smaller program then we do not face this issue.
The axis performs really well and we use offset machine for carving on hard wood.
R/ Irfan
on the other hand there is no issues with the axis or the drives, this is confirmed buy the fact that - immediately if we run a new smaller program then we do not face this issue.
The axis performs really well and we use offset machine for carving on hard wood.
R/ Irfan