Hello Ron:
I tried (3) times to send and attachement, and kept getting messages that it was a duplicte name, or it did not accept that file type, or that I had already had a file with that name in the system. Kind of frustrating.
However, I will write the exact sequence I am talking about since the visual picture is not happening.
1. Select "Newfangled" from the Wizards menu.
2. Material Selection screen opens.
select material from list, and click [Continue] box.
3. Please Choose an Operation screen opens.
make operation choice from 15 available operations listed with graphic pictures.
4 Tool Properties screen opens.
Top center of page is a button; [Select Tool from Table]
5. Click on button.
6. Window pops open on screen with the heading;
[Select Tool from Tool Table]
All the tools in your Tool Table are in this window.
7. Click on a Tool.
8 The tool # is automatically entered into the Tool# black entry box, and the tool diameter is automatically entered into the
black entry box labeled [Tool dia]
9. Click on the OK in lower right corner of [Select Tool from Tool Table] box, and window disappears.
10 You can now enter other selections, i.e., spindle RPM, Feed Rate etc.
11. Click green [Continue] box at lower right corner of screen.
12 The data entry screen opens, for X,Y coordinates, CW, CCW, Inch, Metric ets.
This is the last screen and the Post code, Preview choices are in boxes.
The [Select Tool from Table] window is what I am asking about.
That pop-open window does not work on the 2010 screen set. Perhaps it is because in the 2010 screen set, he has an Icon
at the top of the page, specifically for opening the Newfangled wizards, and something gets lost in the mix.
Thanks
John