1
General Mach Discussion / Help with adding a rotary table on LPT2
« on: December 31, 2009, 02:20:51 PM »
I could use a little insight on adding a rotary table on my router. My current config under Mach3 has A slaved to Y and X and Z drive there axis. My question concerns adding a rotary table under LPT2. Should I configure this axis a B or C as those appear to be my only options or doesn't it matter. I will be using Cut2D to generate my G code. All axis are driven by a Gecko G540 and the rotary will be a G250.
Frank
Frank