1
General Mach Discussion / Has anyone used the cnc spindles from keling
« on: October 29, 2011, 10:07:56 AM »
I have a syil X-6 standard mill with the 1500w brushless motor and I am looking to replace it with something that works. Has anyone used the cnc spindles keling sells? They have a 3 hp with a vfd for around $650.00 the sanmutang motor and driverr I have
in the machine has not workeed right since day one. the machine is still under waranty but I am not looking for another junky motor. any ninput would be appreciated.
Thanks Ken
Specification
OD=80 mm x 180mm, Voltage: 220V
Speed: 6000-24000 R/min
Power: 1500 (2HP)W, Frequency:400 Hz
Water Cooling, ER11 collet chuck
Grease Lubrication, NSK Bearing, Runout off: less than 0.005mm
Water cooling about 20-26 gal/hr
in the machine has not workeed right since day one. the machine is still under waranty but I am not looking for another junky motor. any ninput would be appreciated.
Thanks Ken
Specification
OD=80 mm x 180mm, Voltage: 220V
Speed: 6000-24000 R/min
Power: 1500 (2HP)W, Frequency:400 Hz
Water Cooling, ER11 collet chuck
Grease Lubrication, NSK Bearing, Runout off: less than 0.005mm
Water cooling about 20-26 gal/hr