Topics

1

General Mach Discussion / Has anyone used the cnc spindles from keling

« on: October 29, 2011, 10:07:56 AM »

I have a syil X-6 standard mill with the 1500w brushless motor and I am looking to replace it with something that works. Has anyone used the cnc spindles keling sells? They have a 3 hp with a vfd for around $650.00 the sanmutang motor and driverr I have
in the machine has not workeed right since day one. the machine is still under waranty but I am not looking for another junky motor. any ninput would be appreciated.
                                                                                                                                                                                                                              Thanks Ken



Specification
OD=80 mm x 180mm, Voltage: 220V
Speed: 6000-24000 R/min
Power: 1500  (2HP)W, Frequency:400 Hz
Water Cooling, ER11 collet chuck
Grease Lubrication, NSK Bearing, Runout off: less than 0.005mm
Water cooling about  20-26 gal/hr

2

General Mach Discussion / Please Help ! Can't get mach3 to control coolant pump

« on: September 16, 2011, 07:30:54 AM »

I am using mach3 on a syil x6 mill and I cant get mach3 to turn the pump on and off. If I manually put 24 volts to the coolant pump relay it turns the pump on. I have 24 volts going to the 5 axis board wired to the pump relay. Ihave tried enabling different outputs but I cant seem to figure it out. any help or sugestions would be greatly appreciated. Ken

3

FAQs / coolant pump wiring

« on: August 30, 2011, 06:05:38 PM »

I am using mach3 with a syil x-6 mill and i cant get the coolant pump to work. I have enabled the output#1 and #2 in outputs. when I toggle the flood toggle in diagnostics I get a red light on output 1. the pump was not wired when i got the machine and I dont have a diagram. does anyone know where I can get one?