1
General Mach Discussion / hi !
« on: October 18, 2008, 10:35:31 AM »
hi all!
already having an small cnc machine (proxxom mf70) and cnc3ax power board, actually using JL Soumard's cnc3axes v2.03 software I am looking forward to use mach on this machine, on the myford lathe and on the new router in construction.
so, I am looking to a new cnc software... maybe I should find a newer computer and use dual boot ...
since the PC is running W98 for compatibility with cnc3axes (it is a 1.3GHz pIII) I suppose mach3 will not run in that config... mayybe mach 2?
regards from belgium
sourisbulle
already having an small cnc machine (proxxom mf70) and cnc3ax power board, actually using JL Soumard's cnc3axes v2.03 software I am looking forward to use mach on this machine, on the myford lathe and on the new router in construction.
so, I am looking to a new cnc software... maybe I should find a newer computer and use dual boot ...
since the PC is running W98 for compatibility with cnc3axes (it is a 1.3GHz pIII) I suppose mach3 will not run in that config... mayybe mach 2?
regards from belgium
sourisbulle