Hello Guest it is March 28, 2024, 09:19:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sourisbulle

Pages: 1
1
General Mach Discussion / hi !
« on: October 18, 2008, 10:35:31 AM »
hi all!

already having an small cnc machine (proxxom mf70) and cnc3ax power board, actually using JL Soumard's cnc3axes  v2.03 software I am looking forward to use mach on this machine, on the myford lathe and on the new router in construction.

so, I am looking to a new cnc software... maybe I should find a newer computer and use dual boot ...

since the PC is running W98 for compatibility with cnc3axes (it is a 1.3GHz pIII) I suppose mach3 will not run in that config... mayybe mach 2?

regards from belgium

sourisbulle


Pages: 1