2011
General Mach Discussion / Re: Still confuse about Mach3
« on: May 19, 2013, 12:18:48 AM »
Create a drawing with a 3" cirlce in the center of the 4"square. Create a pocket ( you need the pro version to do this) based on a created tool.
This will machine all the stock from the squareto the circle.
You can also just select the circle and do offsets based on a rough and finishing tool. Also you can add lead in / lead outs.
Continue readng the manual.............
RICH
This will machine all the stock from the squareto the circle.
You can also just select the circle and do offsets based on a rough and finishing tool. Also you can add lead in / lead outs.
Continue readng the manual.............
RICH