NO
The computer is on and Mach 3 is running... When I turn on my cnc I get stepps with my X and Y axis. No other program is running, I am not connected to the internet or any other computer. I am not connected to a printer. It is not a ground issue, both the cnc and table are grounded and the controller and Bread Board. The humitity in the room is set and mantained at 45. The Tempature in the room is 20 degrees C or like 80 degrees F. I have a fan attached to each stepper motor that pushes 60 CMF's of air...I think this should be enough.
Thanks again in advance.
Roger McC.