Change scale on start up Mach3

[marcinpl]

I want change scale on X and Y axis when I turn on Mach3.

I do something like this

in Brain Editor

Estop ------ invert flip signal --------- Formula a*(1.0066) --------- Xscale

it works
buy I still will be looking for optimal solution
best regards
Marcin

[Ron Ginger]

G51 sets a scale factor, so G51 X 1.0066 ought to do what you want. Put that into the init string thats in the Config/general screen and it will execute every time mach starts up. Might be safer to first do G50 to reset all scales to zero, then the G51.

[marcinpl]

Thank You both methods work good. If you say that Yous is more safe I will be use G50 G51 X1.0066 Y1.0066
once again thx