Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 11:36:19 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Mach3 and G-Rex
| | |-+  Mach 4, G-Rex and linear encoders...
Pages: 1   Go Down
« previous next »
Print
Author Topic: Mach 4, G-Rex and linear encoders...  (Read 1401 times)
0 Members and 1 Guest are viewing this topic.
mirkolinux
Holding

Offline Offline

Posts: 1


View Profile
« on: May 02, 2006, 03:36:32 PM »
Hi, i have a question..... Grin

I have a g100, 3 servo, and 3 linear encoders, i use mach 4 in metric units, but what is the optimal motor tuning config for my system?
I have set same of the tutorial, but the value of encoders it does not come considered in the movements of the system.....  Why? is it correct ?
Thanks and hello to all!

p.s. sorry for my bad english... Roll Eyes
Logged
Brian Barker
Administrator
*
Offline Offline

Posts: 3,383



View Profile
« Reply #1 on: May 02, 2006, 05:42:53 PM »
That part of the firmware has not been writen into the G100. I don't know when Steve H. will start to code that in.

Thank you
Brian
Logged
Fixing problems one post at a time Wink

www.newfangledsolutions.com
www.machsupport.com
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!