Phidgets USB and Mach3, need a Post Processor

[crob09]

I was wondering if someone could help me figure out how to make a post processor for a 1062 4 motor controller manufactured by Phidgets.

I really have no idea where to begin so any help undertanding how the post works is greatly appreciated.
Also is it even possable to have a post program for a USB device?
I will be posting any finds here and on my website at http://www.cncstuff.com and you can email me at admin@cncstuff.com

thanks for your help and time.

CNC Phidgets "Post processor"
CNC stuff

[RICH]

Same as the other three posts on the controller your on your owne.

We are also committed to providing clear and simple explanations and instruction.

That is from your site, and just must ask .......
How in the world are you going to support your buisness if you have no idea what you getting into.

Here is a link for a one on one support. You may want make a request there but I must say that the support may involve a fee.
http://www.machsupport.com/forum/index.php/board,18.0.html

RICH