Latest update problem

Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 10:53:57 PM

Machsupport Forum

Mach Discussion

General Mach Discussion

Latest update problem

Pages: 1 Go Down

« previous next »

	Author	Topic: Latest update problem (Read 213 times)
0 Members and 1 Guest are viewing this topic.

Rogeman

Active Member

Offline

Offline

Posts: 2

Latest update problem

« on: June 06, 2011, 08:56:06 AM »

I have just down loaded and installed R3.043.022 on win 7 32 bit. I use TurboCAD15 Cad/Cam.
I only use this system to create the original files but use XP on the actual machine output.
The arc locations now seem to be in the wrong place,the linear postions are Ok.
See attached file.The first file I used was more complicated so drew anothersimple one to prove the point with the same result.
Does anyone have any suggestions please.

Regards

Roger

The second picture is what I expected it to be.

CAM.PNG (5.24 KB, 447x256 - viewed 28 times.) cam_2.PNG (5.55 KB, 559x284 - viewed 22 times.)
« Last Edit: June 06, 2011, 08:59:56 AM by Rogeman »	Logged

derekbpcnc

Active Member

Offline

Offline

Posts: 194

Re: Latest update problem

« Reply #1 on: June 06, 2011, 02:34:51 PM »

Hi,

Dredging my memory I had a similar problem a while ago.

I cured it by changing my cam settings to output arcs in max 90 degree section.
ATB
Derek


	Logged

You can "chop it off" but can't "chop it on"

Rogeman

Active Member

Offline

Offline

Posts: 2

Re: Latest update problem

« Reply #2 on: June 06, 2011, 04:04:39 PM »

Hi Derek,
Thanks for you reply, I am not sure how to achieve that with Turbocad/cam.
As I said it only occured when I updated to the latest Mach3, it was Ok with Ver. 2.6
I have run the same file on 2.6 no problems.

Regards

Roger


	Logged

Pages: 1 Go Up

« previous next »

Jump to: